MATERIAL SAFETY DATA SHEET  LIME

GENERAL INFORMATION OF THE SUPPLIER
DDC KİMYA SAN.TİC.LTD.ŞTİ.

SECTION 1 – IDENTIFICATION OF CHEMICAL PRODUCT
PRODUCT NAME:……………………..Lime
CHEMICAL FAMILY:………………...Drilling Fluid Additive (Calcium Hydroxide)
FORMULA:……………………………..Proprietary
CAS NUMBER:…………………………NA

SECTION 2 – COMPOSITION/INFORMATION ON INGREDIENTS
HAZARDOUS INGREDIENT PERCENT CAS NUMBER PEL
This product is not considered - - None Established
Hazardous as per 29CFR 1910:1200.
The criteria for listing components in the composition are as follows: Carcinogens are listed when
present at 0.1% or greater; components which are other wise hazardous according to OSHA are listed
when present at 1.0% or greater. Non-hazardous components may be listed at 3.0% or greater if no
proprietary in nature. This is not intended to be complete compositional disclosure. Refer to section
14 for applicable states right to know and other regulatory information.

SECTION 3 – HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
APPEARANCE/ODOR:…………………. White granular/powder
SHORT TERM EXPOSURE……………..GENERAL: No significant adverse health effects are expected
to develop with normal use. EYES: Slight to moderate irritant.
SKIN: Persons with pre-existing skin disorders may experience
slight irritation. INHALATION: no adverse effects with
normal use. INGESTION: No significant adverse health
effects are effects are expected to develop if only small amounts
(less than a mouthful) are swallowed.
OSHA REGULATED:…………………… No
LISTED CARCINOGEN:……………….. NTA: No
IARC MONOGRAPHS: No
POTENTIAL HEALTH EFFECTS
INHALATION:…………………………… Irritant
INGESTION:……………………………... Irritant
SKIN (DERMAL):………………………... Irritant
OVER EXPOSURE EFFECTS:……….....No evidence of adverse effects from available information.

SECTION 4 – FIRST AID MEASURES
FIRST AID:……………………………… In case of eye contact, flush immediately with plenty of
Water for at least 15 minutes and get medical attention; for skin, wash thoroughly with soap and water. If affected by inhalation of vapor or spray mist, remove to fresh air. If swallowed, do not induce vomiting get immediate medical attention.

SECTION 5 – FIRE FIGHTING MEASURES
FLASHPOINT:……………………………… > 350° F
EXTINGUISHING MEDIA:………………….
DECOMPOSITION PRODUCTS:…………
LOWER FLAME LIMIT:…………………… NA
HIGHER FLAME LIMIT:…………………... NAUNUSUAL FIRE AND
EXPLOSION HAZARDS:…………………... None Known
FIRE FIGHTING EQUIPMENT:…………… Fire Fighters and others exposed to products of combustion should
wear self-contained breathing apparatus. Equipment should be
thoroughly decontaminated after use.

SECTION 6 – ACCIDENTAL RELEASE MEASURES
CHEMICAL EMERGENCY
NUMBER (24 HOURS):…………………. 1-800-960-6490
SPILL:…………………………………….. In case of spillage, dilute with water to sewer if allowed by local
regulations, or absorb with inert material and dispose of in
accordance with applicable regulations.
RCRA STATUS:…………………………. None

SECTION 7 – HANDLING AND STORAGE
HANDLE IN ACCORDANCE WITH GOOD INDUSTRIAL HYGIENE AND SAFETY PRACTICES.
THESE PRACTICES INCLUDE AVOIDING UNNECESSARY EXPOSURE AND PROMPT
REMOVAL OF MATERIAL FROM EYES, SKIN AND CLOTHING.
HANDLING AND STORAGE:………….. No special storage requirements.
PRECAUTIONARY
MEASURES: Provide fresh air ventilation during and after application. Close
container after each use. Avoid prolonged or repeated contact
with skin, eyes and clothing. After handling this product, wash
hands before eating, drinking or smoking. If needed, take first
aid action shown in Section 4.

SECTION 8 – EXPOSURE CONTROL/PERSONAL PROTECTION
GENERAL CONSIDERATIONS:
Consider the potential hazards of this material (see section 3), applicable exposure limits, job activities, and
other substances in the work place when designing engineering controls and selecting protective equipment.
EYE PROTECTION:…………………… Use goggles or face shield id splashing is likely.
RESPIRATORY PROTECTION:……… Not normally needed. Use NIOSH approved vapor respirator if
exposure is unknown or exceeds permissible limits.

Use NIOSH/MSHA approved respiratory protection equipment when airborne exposure limits are
exceeded (see below). Consult the respirator manufacturer to determine appropriate type of
equipment for a given application. Observe respirator use limitations specified by NIOSH/MSHA or
the manufacturer. Respiratory protection programs must comply with 29 CFR 1910.134

PROTECTIVE GLOVES:……………….. Wear impervious gloves (Chemical Resistant)
VENTILATION:…………………………. Local exhaust
MECHANICAL EXHAUST:……………. Desired in closed places
LOCAL EXHAUST:……………………... Recommended
VENTILATION NOTES: Provide natural or mechanical ventilation to control exposure levels below
Airborne exposure limits (see below). The use of local mechanical exhaust ventilation is preferred at
sources of air contamination such as open process equipment. Consult NFPA Standard 91 for design
of exhaust systems.
THRESHOLD LIMIT VALUE:…………. ACGIH TWA – TVL 3a5 MG/M
PROTECTIVE EQUIPMENT: HMIS PERSONAL PROTECTION: B: Safety Glasses, Gloves
The user should read and understand all instructions and limitations supplied with the equipment
since protection is usually provided for a limited time or under certain circumstances.

SECTION 9 – PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE/ODOR:……………………..……. Light color granules, odorless
BOILING POINT:………………………………… N/D
FREEZING POINT:……………………………….. N/D
VAPOR PRESSURE:………………………………
VAPOR DENSITY (AIR = 1):……………………. N/A
SPECIFIC GRAVITY:……………………………. 2.3 – 2.4
pH:…………………………...………………………N/A

SECTION 10 – STABILITY AND REACTIVITY
STABILITY:………………………………………. Product not stable
HAZARDOUS POLYMERIZATION:...…………. Will Not Occur
POLYMERIZATION AVOID:…………………… None
INCOMPATIBILITY:……………………………. Strong oxidizers and oxidizing materials due to
hydrocarbon nature of material
CONDITIONS TO AVOID:………………………. None known

SECTION 11 – TOXICOLOGICAL INFORMATION
EYE EFFECTS:
The eye irritation hazard is based on data from information supplied by raw material(s) supplier(s).
SKIN EFFECTS:
The skin irritation hazard is based on data from information supplied by raw material(s) supplier(s).
ACUTE ORAL EFFECTS:
The acute oral toxicity is based on data from information supplied by raw material(s) supplier(s).
ACUTE INHALATION EFFECTS:
The acute respiratory toxicity is based on data from information supplied by raw material(s) supplier(s).

SECTION 12 – ECOLOGICAL INFORMATION
Data from laboratory studies and from scientific literature is noted below if available.

SECTION 13 – DISPOSAL CONSIDERATIONS
WASTE DISPOSAL:……………………….……… Follow State Regulations.

SECTION 14 – TRANSPORTATION INFORMATION
The data provided in this section if for information only. The description shown may not apply to all
shipping situations. Consult 49 CFR, or appropriate regulations to properly classify your shipment for
transportation.
PROPER SHIPPING NAME:…………………...… DOT NON-REGULATED – LIME
REPORTABLE QUANTITY:………………….… None
HAZARD CLASS AND LABEL:………………… None
UN NUMBER:……………………………………… None
NA NUMBER:……………………………………… None
PACKAGING SIZE:………………………………. All (25# Bag)

SECTION 15 – ADDITIONAL INFORMATION
** Please Note: The above provided information is as per our best knowledge and long research. It may be differ to place to place and method of use of this product. This information is given for safe
handling and use of this material. DDC will be not responsible for any claim regarding the above information.